GREEN ROOF PROGRAM Now Available in TX - Claim Your Free Roof Today!

Deer Park, TX Solar Panel Removal and Reinstallation for Roof Work

When the roof under an array needs work, the panels have to come off. Done right, they go back on with the roof sealed tight around every mount.

Schedule Your Roofing Inspection Today

Fill out the information below and we’ll reach out to complete your estimate as soon as possible!

Call (844) 980-5506
20+ yearsOf experience
FinancingIs also available
DiscountsMilitary, first responders and seniors
Family ownedFully licensed and insured
Houston · DFWAustin · San Antonio

Why panels come off Deer Park roofs

Two things usually force the job: age and storms. Half of the homes in Deer Park were built before 1982 (U.S. Census Bureau, American Community Survey 2020-2024). Some panels were installed on roofs that were already halfway through their life. A few years later, the shingles under the array wear out before the panels do.

Storms are the other trigger. NOAA's Storm Prediction Center logged 7 hail reports of 1.75 inches or larger within 10 miles of Deer Park from 2015 through 2024, in 2019, 2023 and 2024. When hail damages the roof, the section under the panels needs the same repair as the rest. Leaving it in place means a weak spot right under the array.

Leaks at mounts are a third reason. A flashing that was not installed well, or sealant that has dried out, lets water into the deck. Fixing it means lifting the panels over that area.

Some owners also decide to replace the roof before a sale. Buyers and their inspectors often ask how old the shingles under an array are. Having a new roof under the panels, with paperwork showing when the work was done, answers that question before it becomes a point in the negotiation.

What a careful removal protects

The panels

Handled and labeled so the glass and frames are not damaged.

The layout

Photos and notes so each panel goes back where it was.

The rafters

Mounts reset into solid framing, not old holes in tired wood.

The roof seal

New flashing at each attachment, tied into the new shingles.

The wiring

Cables are kept organized and off the roof surface while the work is done, then routed back the way they were.

The job, in order

1

Inspection

Check the roof, the array and the attic. Note leaks, deck damage and hail marks, and photograph the system as it stands.

2

Plan and estimate

One written estimate that covers removal, roof work and reinstallation.

3

Take the array down

Panels and racking come off.

4

Roof work

Repair or replace, including decking and underlayment where needed. See roof replacement in Deer Park.

5

Reinstall

Mounts go back with new flashing, then rails and panels.

6

Final check

Confirm the array is secure and the roof around it is sealed. Look in the attic after the next good rain to make sure no mount is letting water in.

Before you schedule

Find the original installation paperwork if you have it.

Ask how the panels will be stored and protected during roof work.

Ask whether mounts and flashing will be replaced or reused, and why.

Clear a spot in the yard or driveway where panels can be stored during the job.

If hail caused the damage, read your policy and keep photos. See roof insurance claims.

Plan the roof and panel work together so one schedule covers both.

GemSco does solar panel removal and reinstallation along with roof repair and replacement. Estimates are free. More on our solar panel removal and reinstallation page.

Frequently Asked Questions

How do I know if the roof under my panels is damaged?

Signs include stains on ceilings near the array, granules in gutters below it, or hail damage on other parts of the roof. Since panels block the view, a roofer may need to look from the edges and in the attic. After a large-hail storm, it is worth checking even without a leak.

Is it better to remove panels for a repair or work around them?

Small repairs at the edge of an array can sometimes be done in place. Anything under the panels, or a full replacement, needs removal. Working around panels risks a weak repair and damage to the system. A roofer should tell you which case applies before work starts.

Can I upgrade my roof material when panels come off?

Yes. When the array is off, you can switch to a different shingle or to metal. The mounts must match the new roof type, so plan it together. Read about asphalt vs. metal in our blog before you choose, and ask how each one works with your panel mounts.

We’re Here to Help!

GemSco Roofing & Solar serves Houston, DFW, Austin, San Antonio and surrounding areas. We’re family owned and fully licensed and insured.

Call (844) 980-5506 GET A FREE QUOTE
Call GET A FREE QUOTE