
Signs of rotted roof decking: what to look for before the shingles come off
Rotted roof decking shows up as soft or sagging spots on the roof, and as dark stains, damp wood, mold or a musty smell on the underside of the boards in your attic. Many cases stay hidden until a tear-off, so the attic is your best early warning.
Schedule Your Roofing Inspection Today
Fill out the information below and we’ll reach out to complete your estimate as soon as possible!
What roof decking is and why rot matters
The decking, also called sheathing, is the layer of plywood, OSB or wood boards nailed to the rafters. Every shingle nail goes into it. If the wood is soft, nails lose their grip, and shingles can lift or blow off in the next windstorm.
The code expects a solid base. A Louisiana State University AgCenter guide to code-compliant roofing explains that the IRC requires asphalt shingles to be fastened to solidly sheathed decks, meaning a solid, continuous deck material. Rotted boards are not that.
Rot also spreads. Once wood stays wet, the damage grows from the original leak or damp spot to the boards around it. Catching it at one or two sheets is very different from finding it across a whole slope.
Signs you can see from the attic
Dark stains on the boards
Brown or black patches on the underside of the decking, often around chimneys, vents, valleys or seams. Stains with rings mean water has come and gone more than once.
Wood that feels soft
Press gently with a screwdriver tip. Sound wood resists. Rotted wood gives, flakes or lets the tip sink in.
Rusty nail tips
The shingle nails that poke through the decking should look clean. Rust or dark rings around them point to repeated moisture.
Mold or a musty smell
White, green or black growth on the decking or rafters, or damp, clumped insulation below it.
Daylight or sagging
Pinholes of light, gaps at seams, or boards that dip between rafters.
Powdery or crumbling wood
Rot is not always wet. Some decay leaves dry, crumbly wood with a white or yellowish residue.
Signs you can see from outside
From the ground, look along the roofline. A straight ridge and flat planes are what you want. A wavy surface, a dip between rafters or a slope that looks bowed can mean the decking under the shingles has softened or swelled.
Shingles can also give it away. Buckled, lifted or uneven shingles sometimes sit on decking that has moved underneath. If you are not sure whether you are looking at age or something deeper, compare with why shingles curl, crack or fall off.
Do not walk the roof to test it. A soft spot that feels spongy underfoot is a classic sign for a roofer, but it is also where a person can step through. Leave the walking to someone with fall protection.
What causes deck rot in Texas homes
Water is the cause in almost every case, and it gets there two ways. The first is a leak: failed flashing, a cracked boot around a vent pipe, missing shingles after wind or hail. Small leaks can soak the decking for months before a ceiling stain appears, as covered in can a roof leak without ceiling damage.
The second is moisture from inside the house. GAF lists condensation in the attic as one of the most common causes of wood rot, because a poorly vented attic traps humid air that condenses on the underside of the deck.
Bathroom fans are a frequent culprit. The IRC says air from an exhaust fan must be discharged outdoors, not into an attic, soffit or ridge vent. A fan duct that ends loose in the attic sends shower steam straight at the decking every day.
Ventilation helps the attic dry out. The Department of Energy's building guidance from PNNL recommends good roof vents plus insulation baffles so air can move under the roof and dry condensation when it happens. See how roof ventilation protects your home for the basics.
A 15-minute attic check you can do today
Pick a dry, cool morning
Texas attics get dangerously hot by afternoon. Go early, bring water, and tell someone you are up there.
Bring a flashlight, phone and screwdriver
Step only on the joists or a walk board, never on the insulation or drywall between them.
Start at the problem zones
Look first at the chimney, plumbing vents, valleys, the bathroom fan area and the lowest edge of the roof near the eaves.
Look, then lightly probe
Check for stains, mold, rusty nails and light. Press the screwdriver into any stained spot to see if the wood is soft.
Follow the fan ducts
Make sure each bathroom fan duct runs to a vent cap outside, not into the open attic.
Photograph everything
Take wide shots and close-ups with something for scale. Those photos help any roofer judge the problem before they arrive.
Why most rot is found during the tear-off
From the attic you only see the underside of the boards and only where you can reach. The top surface is covered by underlayment and shingles. That is why a roofer may quote a replacement and still say decking will be checked once the old roof is off.
Not every stain means rot. A dark spot on wood that is hard and dry may be left from an old leak that was already fixed. Mark its edge with a pencil and check again after the next heavy rain. If the spot is damp, softer or bigger, the leak is still active.
When rot is found, the fix is to cut out the bad sections and install new sheathing, and GAF notes that the moisture source has to be fixed first or the new wood will rot too. An overlay skips this step entirely, which is one reason a tear-off is often the better choice.
Most surprise bills come from this moment. A good roof replacement estimate says up front how damaged decking is handled, so a soft sheet on day one is a planned item, not an argument.
What to ask before you sign a replacement contract
How will damaged decking be priced: per sheet, by the hour or as a set allowance?
Does that price include tear-out, disposal, fasteners and new underlayment over the new wood?
Will you send photos of every sheet you replace, before and after?
Will you call me before going over a set number of sheets or dollar amount?
If you find rot, will you also tell me what caused it, like a vent, flashing or ventilation issue?
Is any decking work already in the estimate, or only what you find after tear-off?
When to call a roofer
Call soon if you find soft wood, active drips, mold on the decking or a sagging section. Those do not get better on their own, and a wet deck will not hold new nails well. A roof inspection can map the stains in the attic to what is happening on the roof and tell you whether a roof repair is enough.
If your roof is near the end of its life anyway, compare roof repair vs replacement before you fix one sheet at a time. Either way, ask for a written estimate that names the decking plan in plain words.
Frequently Asked Questions
How do I know if my roof decking is rotted?
Check the attic first. Look for dark stains, damp or soft wood, mold, rusty nail tips, light coming through and sagging between rafters. From outside, a wavy roofline or a dip in a slope is a warning sign. Many problems can only be confirmed when the old shingles are removed.
Can you put new shingles over rotted decking?
No. Shingles need a solid, continuous deck to hold their nails, and wet or deteriorated decking is a reason the code does not allow a recover. Rotted sections need to be cut out and replaced, and the source of the moisture fixed, before a new roof goes on.
Can rotted roof decking be repaired instead of replaced?
Usually the rotted section is cut out and replaced with new plywood or OSB, while sound boards around it stay. Patching over soft wood does not restore its ability to hold nails. The leak or condensation that caused it has to be fixed at the same time.
What causes roof decking to rot without a leak?
Attic moisture. Humid air from the house, especially from bathroom fans that vent into the attic, can condense on the underside of the decking. Poor attic ventilation keeps that moisture from drying out, and the wood slowly rots from below.
Keep Reading
Roof over vs tear off: can you put new shingles over the old ones in Texas?
Learn MoreHow Proper Roof Ventilation Helps Protect Your Home
Learn MoreCan a Roof Leak Without Visible Ceiling Damage?
Learn MoreRoof Repair vs Replacement: How to Decide
Learn MoreRoof Replacement
Learn MoreRoof Inspection
Learn MoreWe’re Here to Help!
GemSco Roofing & Solar serves Houston, DFW, Austin, San Antonio and surrounding areas. We’re family owned and fully licensed and insured.

