GREEN ROOF PROGRAM Now Available in TX - Claim Your Free Roof Today!

Solar Panel Removal and Reinstallation in Seagoville

When the roof under your solar array needs work, the panels have to come off first. Here is how that job should go from start to finish.

Schedule Your Roofing Inspection Today

Fill out the information below and we’ll reach out to complete your estimate as soon as possible!

Call (844) 980-5506
20+ yearsOf experience
FinancingIs also available
DiscountsMilitary, first responders and seniors
Family ownedFully licensed and insured
Houston · DFWAustin · San Antonio

When panels need to come off

A full roof replacement on a home with an array.

A leak traced to a spot under or near the panels.

Hail or wind damage on the roof under the array.

Rotted or soft decking that has to be replaced.

A switch to a different roofing material with different mounts.

Seagoville roofs with panels on them

Half of the homes in Seagoville were built before 1992 (U.S. Census Bureau, American Community Survey 2020-2024). Panels added to some of those homes may now sit on roofs that are wearing out. The shingles under an array keep aging, even if they are shaded from the sun.

Storms add pressure. The largest hail reported within 10 miles of Seagoville from 2015 through 2024 measured 3.5 inches, on April 20, 2023, according to NOAA's Storm Prediction Center. When a storm damages the roof under an array, the panels must be moved so the damaged area can be repaired and documented. See hail damage roof repair in Seagoville for that process.

How removal and reinstallation works

1

Document the array

Photos of the panels, wiring and layout are taken before anything moves.

2

Confirm the electrical side

The electrical shutdown belongs to your solar provider or an electrician. Settle who does it before any panel moves.

3

Remove with care

Panels and racking come off carefully.

4

Repair the roof

Decking, underlayment, shingles and flashing are fixed or replaced as needed. See roof replacement in Seagoville.

5

Reinstall and seal

New flashing goes in at each mount, and the panels are set back in place.

Questions to ask before work starts

Ask who will handle the shutdown and reconnection, how panels will be stored, and whether the mounts will get new flashing. If your system is leased, check the contract to see who must approve removal. Ask for the plan in writing.

Doing the roof and the panels with one team keeps the work coordinated, which lowers the chance of leaks at the mounts later. It also means one schedule and one point of contact, so the array is not left sitting in the yard while two crews wait on each other.

Repair now or replace while panels are off

If the roof under the array is aging, think about the timing. Removing the panels twice, once for a repair and again for a replacement a few years later, doubles that step. When a house is decades old and still on an aging roof, a replacement during the same visit is often worth pricing out. Our guide on roof repair vs. replacement can help you decide.

GemSco handles both the roof and solar panel removal and reinstallation, with 20+ years of experience and free estimates. Learn more about solar panel removal and reinstallation or our work in Seagoville.

Why it pays to plan ahead

Avoid a second removal

If the roof is close to the end of its life, replacing it while panels are off can save another removal later.

Fresh flashing

Every mount is a chance to reset the seal around a hole in the roof.

Clear records

Photos before and after help with any future insurance or service questions.

Frequently Asked Questions

Do I need to remove solar panels to replace my roof?

Yes. The roof under the array cannot be replaced with panels in place. They come off, the roof is replaced, and the panels go back up with new flashing at the mounts. Planning it as one job keeps the work coordinated and the roof watertight.

Can solar panels be reused after removal?

Usually, yes, if they are in good condition and handled carefully. Panels that were cracked by hail or damaged in a storm may need to be replaced instead. Ask for photos of the panels before and after removal so you know their condition.

What should I check if my panels are leased?

Read your lease or contract before any work. Some agreements say who must remove and reinstall the panels or require notice before the system is moved. Knowing this ahead of time avoids delays and confusion once the roof work starts.

We’re Here to Help!

GemSco Roofing & Solar serves Houston, DFW, Austin, San Antonio and surrounding areas. We’re family owned and fully licensed and insured.

Call (844) 980-5506 GET A FREE QUOTE
Call GET A FREE QUOTE