GREEN ROOF PROGRAM Now Available in TX - Claim Your Free Roof Today!

Removing and Reinstalling Solar Panels for Roof Work in Red Oak

When the roof under a solar array needs repair or replacement, the panels must come off first. Handled carefully, the system goes back on a sound roof with new seals.

Schedule Your Roofing Inspection Today

Fill out the information below and we’ll reach out to complete your estimate as soon as possible!

Call (844) 980-5506
20+ yearsOf experience
FinancingIs also available
DiscountsMilitary, first responders and seniors
Family ownedFully licensed and insured
Houston · DFWAustin · San Antonio

How the job is done

1

Inspect the roof

Confirm what needs fixing under and around the array. A roof inspection in Red Oak gives you photos.

2

Document the system

Record panel layout, wiring and mount positions before removal.

3

Remove the panels

Take off panels and racking in order, with care.

4

Do the roof work

Repair or replace the exposed roof, including deck, underlayment and flashing.

5

Reinstall and seal

Re-flash each mount, then reinstall racking and panels in the same layout.

6

Check and photograph

Confirm the system is working and keep photos of the finished work.

Why Red Oak homeowners need this

Half of the homes in Red Oak were built before 2007 (U.S. Census Bureau, American Community Survey 2020-2024). If panels were installed on an original roof, that roof may need replacing long before the panels wear out. Removal and reinstallation lines up the two.

Storms add urgency. NOAA's Storm Prediction Center logged 77 hail reports within 10 miles of Red Oak from 2015 through 2024, and 15 of them were 1.75 inches or larger. Large hail fell in 2021, 2023 and 2024, after only one such year, 2015, earlier in the decade. The biggest stone, 3.75 inches, came on June 14, 2023. If hail damaged the shingles around your array, the ones underneath may need work too.

Reasons to take the panels off

A leak in a room below the array.

Hail damage on the roof around the panels.

A full roof replacement on an aging roof.

Wind damage that lifted shingles near the racking.

Moving or rearranging panels during other work.

Benefits of one contractor for both

One schedule

Removal, roofing and reinstall are planned together, so the system is not off longer than needed.

One point of contact

If a mount leaks later, there is no back-and-forth between companies.

Integrated sealing

Mount flashing is installed as part of the new roof surface.

Better records

Photos of the roof under the array are taken while it is exposed, which helps with any future repair or claim.

Questions to settle before work starts

Ask who powers the system down and who confirms it is working afterward. Ask where the panels will be stored and how they are protected. Ask whether every mount gets new flashing and whether the written estimate lists removal, roofing and reinstall as separate items.

Clear answers up front avoid surprises later. If you also want to change the layout or add panels, raise it now, while the array is already coming off.

Insurance, planning and next steps

If storm damage is behind the work, panel removal and reinstallation is something to discuss with your adjuster. What is covered depends on your policy and insurer. Read about roof insurance claims and our guide on things to do before replacing your roof.

GemSco handles solar panel removal and reinstallation along with the roofing in between. We are family owned, fully licensed and insured, with 20+ years of experience, and estimates are free. Learn more about our solar panel removal and reinstallation service or our Red Oak roofing page.

Frequently Asked Questions

Can I leave my panels on during a roof replacement?

No. A full replacement requires taking the old roof off down to the deck, which cannot be done under the panels. The array has to be removed and reinstalled. Planning this with one contractor keeps the process simpler.

What happens to my system while the panels are off?

It is shut down and does not produce power until it is reinstalled and reconnected. Panels and racking stay off the roof during the roof work. Ask your contractor for a clear schedule so you know when the system will be back online.

Will the reinstalled mounts leak?

They should not if they are re-flashed and sealed as part of the new roof. Reusing old seals is a common cause of leaks after reinstall. Ask how each mount will be flashed and request photos before the panels go back on.

We’re Here to Help!

GemSco Roofing & Solar serves Houston, DFW, Austin, San Antonio and surrounding areas. We’re family owned and fully licensed and insured.

Call (844) 980-5506 GET A FREE QUOTE
Call GET A FREE QUOTE