Gutters in Murphy: Built for Big Storms and Heavy Rain
In Murphy, gutters take a beating from the same storms that hit the roof. Dents, loose seams and overflow are often the first signs of trouble.
Schedule Your Roofing Inspection Today
Fill out the information below and we’ll reach out to complete your estimate as soon as possible!
What storms do to gutters
Dents and crushed sections
Large hail flattens the front edge and can bend the gutter out of pitch.
Granule buildup
Shingle grit washed off by hail settles in the trough and slows drainage. Our guide on how to identify hail damage on asphalt shingles explains why it matters.
Loose hangers
Heavy, fast rain loads gutters with weight. Weak hangers pull out of the fascia.
Overflow
Downspouts that are too small or clogged send water over the edge and down the wall.
Murphy's storm numbers and your gutters
NOAA's Storm Prediction Center logged 131 hail reports within 10 miles of Murphy from 2015 through 2024, and 49 were 1.75 inches or larger. Gutters are one of the first places that damage shows, because thin metal dents easily. After a storm, dented gutters are a good reason to have the roof itself checked too.
Half of the homes in Murphy were built before 2005 (U.S. Census Bureau, American Community Survey 2020-2024). Many gutters here are original or close to it. After years of storms and sun, sealant at seams and corners dries out, and the fascia behind can start to soften where water has been getting through.
Many Murphy houses also have long roof runs and multiple levels. Water from an upper roof can pour onto a lower one and end up in a single gutter that was never sized for it. Those corners overflow first, and the fascia and soffit there tend to show damage before anywhere else on the house.
Signs your gutters need work
Water spilling over the front during moderate rain.
Drips at corners and seams.
Gutters sagging or separating from the fascia.
Peeling paint or dark streaks on the fascia boards.
Pooling water or soil washout near the foundation.
How a gutter job is done right
Measure the roof areas
Each gutter run is sized for the roof area that drains into it.
Inspect the fascia and drip edge
Rotted wood is replaced before new gutters go up, so they hold tight.
Set the pitch
Gutters are sloped toward downspouts so water does not sit.
Place downspouts
Enough outlets, placed to move water away from the foundation.
Seal and test
Seams and corners are sealed, and the system is checked with water.
After a storm
Take photos of gutter dents and downspout damage as part of your storm records, along with the roof, siding and screens. Our list of photos to take after roof storm damage helps you cover everything.
Then clear out granules and debris so the system drains before the next rain. If you see a large pile of shingle grit, that is a sign to have the roof inspected, not just the gutters cleaned. A roof that lost its granules will age faster in the sun.
Gutters and the roof together
Gutter trouble often points to roof trouble, and the reverse is true too. If your roof is due, it can make sense to coordinate new gutters with roof replacement in Murphy. Some owners also ask about gutter guards to reduce cleaning; they are a general market option, and fit depends on your roof and trees.
GemSco does gutter installation and repair along with roofing, with free estimates. Learn more about our gutter repair service or about GemSco in Murphy.
Frequently Asked Questions
Can dented gutters be repaired, or do they need replacing?
Small dents often do not affect drainage. Deep dents, crushed sections or dents that change the pitch usually mean replacing that run. If hail dented the gutters, the roof likely took hits too, so photograph both and have the roof checked.
Why do my gutters overflow even when they are clean?
The gutter or downspouts may be undersized for the roof area, or the pitch may be wrong. Heavy downpours can overwhelm a system that works fine in light rain. Adding downspouts or using larger outlets often solves it.
Should I replace gutters before or after a new roof?
Usually at the same time or right after. The roof edge, drip edge and fascia are exposed during a roof job, which makes it easy to fix rot and set new gutters correctly. Doing them separately can mean taking gutters down twice.
More Roofing Help in Murphy
Roofing in Murphy, TX
City overviewRoof Repair in Murphy
Learn MoreRoof Replacement in Murphy
Learn MoreStorm & Hail Damage in Murphy
Learn MoreRoof Inspection in Murphy
Learn MoreCommercial Roofing in Murphy
Learn MoreSolar Panel Installation in Murphy
Learn MoreSolar Removal & Reinstall in Murphy
Learn MoreGutters Near Murphy
We’re Here to Help!
GemSco Roofing & Solar serves Houston, DFW, Austin, San Antonio and surrounding areas. We’re family owned and fully licensed and insured.